The play button works correctly after the update. Both on the device and via the Rm3 remote control. And the multifunction button, when assigning the "play/pause" function, still stops working after a long pause.

Don't know. I have no complaints yet. About the new firmware. Except for the multifunction button, which still does not respond after a pause.But these are small things for me. I use only a third-party player, unlike the built-in "FiiO Music" and it saves me.

The playback button problem has been fixed. But it remains to solve the problem with the multifunction button. It still turns off after the device goes into standby mode. Especially if you have set up the play/pause mode.

That's another thing! Well done! You can do it whenever you want.

My previous Ibasso dx160 didn't have this problem either. There is a life hack. Press the play button and press again while holding for 2-3 seconds.

Also in the sense that to return 20 percent to those who have already acquired. A device with defective software.Or a full refund with the return of the device.

And these promises have been made since March 2023.

I know this is a firmware issue. And this is essentially a firmware defect. And it must be fixed within the warranty period. Or provide a discount of at least 20 percent of the total cost of the device. IMO.

The fact that after pausing, after a couple of minutes it is impossible to resume playback with a single button press. You have to press the play button three or five times. Resetting to factory settings or rebooting does not help. It remains only to give it for repair or refund.

The warranty is ending. And the error with the button is still not fixed.

Hello! Will there be a firmware update? And about when is the new firmware planned?

Good afternoon! Please fix the "Play/Pause" button. To avoid pressing three times after a pause.

1. Install a third-party music app. (check in the screen menu to display the sampling rate). 2. Disable the "Fiio Music" application in the settings menu of application management. 3. Turn off the device. 4. Turn on the device. 5. Start playback with the installed third-party application. 6...

Х

Hello! The sampling rate is not displayed correctly and there is no playback via SPDIF. On any third-party players. Until you open/close Fiio Music.