mrjayviper
500+ Head-Fier
- Joined
- Jul 23, 2012
- Posts
- 542
- Likes
- 1,250
so I have 4 channels for the amp which means I can use bridge mode. but my question is on how do I wire the input and output so both modes works (but NOT at the same time)?
(I will manually disconnect the input cables if they are unused so I don't have to use a input switcher)
These are my thoughts:
(I will manually disconnect the input cables if they are unused so I don't have to use a input switcher)
These are my thoughts:
- on the input side and when using RCAs, do I connect the R- channel input to R-ground and then L- channel input to L-ground?
- on the output side and when using RCAs, no changes.
- on balanced input, no changes are made to both input and output.